Faxback AudioCodes Mediant 1000 - Configuration Guide Manual de usuario Pagina 3

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 13
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 2
AudioCodes Mediant 1000 Conguration Guide age 3
Before You Begin
ere are a few things you will need before you get started installing your new Mediant 1000.
• One Ethernet patch cable.
• A 19” rack or other place to mount the appliance. Rails may be needed depending on rack hardware.
• One static IP address on the same subnet as your fax server.
• Sucient telephone and/or ISDN PRI cables to connect the telephony modules.
• If using T1 or PRI trunks, you will need the exact conguration specication from the trunk provider (telco).
• A PC connected to the same subnet the Mediant 1000 will be on. e PC will need a web browser to connect to the Web UI of
the Mediant 1000.
In addition, the following are recommended.
• An Uninterruptable Power Supply (UPS) with USB monitor interface.
Connecting the Mediant 1000 to the Network
Media Gateway: On the front of the appliance you will see two RJ45 Ethernet connections on the “CPU” module labeled “I
andII. Connect “I” to your network using an Ethernet patch cable.
Plug the power cable in, the Mediant 1000 will power on after a short pause.
On the PC, congure its IP address:
IP Address10.1.10.200
Subnet Mask255.255.0.0
You will now be able to access and congure the Mediant 1000.
Accessing the Media Gateway via Browser
Media Gateway IP Address10.1.10.10
Open a web browser, and navigate to hp://10.1.10.10/
You will see a login prompt. Enter
UserAdmin
PasswordAdmin
Assign Static IP Addresses
e rst step is to assign static IP addresses to the Mediant so you can congure it on the regular network.
Media Gateway Component
Connect to the Media Gateway IP (10.1.10.10) via a web browser. Navigate to Network Settings > IP Settings, and enter the IP
Address, Subnet Mask and Default Gateway Address as appropriate for your network.
Click “Submit” at the bottom right corner of the page. You can now access the Media Gateway component at its assigned IP
address.
Vista de pagina 2
1 2 3 4 5 6 7 8 ... 12 13

Comentarios a estos manuales

Sin comentarios