Faxback NET SatisFAXtion 9.0 - Fax Server Manual Manual de usuario descargar pdf (Pagina 187)



show_ring0_buffer_size [dword 0–4294967295]: How big of buffer for the page locked          

debug buffer that ring0 code writes to and ring3 code extracts from (on a thread) to the                

debugging output. This should be larger for when using serial capture mode since so much more               

data is written for debug. It should probably be only about 1K for when using T.30 debug since                 

the frequency and amount of T.30 debug is small enough that the ring3 code can easily keep up                 

writingtotheshowoutput.Default:65536.



sip_from_domain[string]:OverridesthedomainpartoftheFromheader.



sip_port_number [dword 1–65535]: Specifies the port number that the IP fax driver will use             

to listen for SIP packets that are delivered over UDP. If the specified port number is used by                 

another application on the same computer (using UDP), then the IP fax driver will not load.               

Default:5060.



sip_max_forwards [dword 0–256]: Specifies the value that the IP fax driver will set for the              

MaxForwards:fieldinSIPmessagesthatitsends.Default:70.



sip_sdp_username [string]: The name to use in the o= owner attribute in the SDP. Default:              

IPFax.



sip_proxy[string]:TheIPaddressorhostnametouseasaSIPproxy.



sip_proxy_password [string]: If the SIP proxy challenges for authentication, use this          

password.



sip_proxy_user_name [string]: If the SIP proxy challenges for authentication, use this user           

name.



sip_registrar[string]:TheIPaddressorhostnametoREGISTERwith(the“registrar”).



sip_registrar_aor [string]: The AoR to use for the REGISTER message. Typically set to the             

sameastheusername.



sip_registrar_password[string]:ThepasswordtousefortheREGISTERmessage.



sip_registrar_refresh_seconds [dword 0–65535]: When registration is enabled, refresh the        

registration after this many seconds. If set to zero, the refresh is sent after 80% of the                

registrar’s “expires” response. If the registrar does not specify an “expires”, then the            

registrationisrefreshedevery60seconds.



sip_registrar_user_name[string]:TheusernametousefortheREGISTERmessage.



sip_remote_ip_address [string]: Specifies the IP address, and optionally port number, of the           

T38 router/gateway that the IP fax driver will use when sending faxes. The router/gateway             

must support SIP 2.0 over UDP. If an IP address is provided without a port number, for                

example, 10.0.0.15, then the IP fax driver will use a port number of 5060. To provide an                

alternate port number, append a colon (:) then port number to the IP address, for example,               

10.0.0.15:5061.



sip_mode[string]:ThisgovernsalternatebehaviorsforIP_FAXinitialINVITE.



Format:Commaseparatedlistofthefollowing:

T38_INVITE–OutboundinitialINVITEwillspecifybothG.711μlaw/T.38initsSDP.



ProprietaryFaxBack,Inc.2014 187

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 202 203

Comentarios a estos manuales

Sin comentarios

Faxback NET SatisFAXtion 9.0 - Fax Server Manual Manual de usuario Pagina 187

Comentarios a estos manuales

Relacionado con productos y manuales para Software Faxback NET SatisFAXtion 9.0 - Fax Server Manual